Hey, what'a ya know... a new post!

Here are some of the most recent pictures. These guys mount between the engine mount platforms on the frame and the actual engine mounts. I built them out of 1/8" plate.



From below when mounted to the frame. I'll need to grind away a little bit of that weld so that the washers will fit flush against the frame.



Another view from the bottom, this time from the rear a little bit.



This is one of the reasons why I haven't been making a lot of progress on the 7 recently. Those new steps I made have to go where I ripped up the old ones. Thanks for the router Dad.